diy beton

i modeled the shape of the candlestick and developed the scan printing on thick paper scan, i cut and glued the candlestick model in physical size and then plastered it with duct tape it will serve asfor the manufacture of reverse mold out of silicone i use a two-component silicone for mould filling first, i will cast the necessary amount of silicone

then watch his weight and in proportion count how much hardener now i will install model of candlestick in the formwork and begin to pour the silicone in the center of the candle holder now i will leave my uniform in silicone for 16 hours so, enough time has passed now i'm going to disassemble the formwork

i took out the silicone form now and finalize drill a hole in the center then it was easier to remove the concrete candle holder i modified the form expanded the hole and i hope that it will be easy to removed the candlestick first, i will seal up the hole in our form that there will not hit the cement i need to process all the internal surface

soap solution now i'm going to mix the cement i chose a quickly solidifying the mixture and will be diluted 1/1 you need to vibrate the form to expel extra air the concrete froze for about 5 hours and now it is solid i will try to get it out of the mold without damaging it

if you liked my experiences using concrete and silicone subscribe to our channel i and many more will experiment with materials